Crawl Space Insulation in Toronto, ON
We put a moisture barrier down on the ground first, then insulate either the walls or the floor above, whichever suits the space.
Our crew does crawl space insulation in Toronto for houses, rentals and small commercial spaces. The moisture barrier goes on the ground first. After that we insulate the walls or the floor above, depending on the space. It works for any room over a crawl space that stays cold, whether that's an addition or a porch someone closed in years ago. We look at the space before we give you a firm quote.
Crawl spaces under additions and porches
If part of your house sits over a crawl space, the floor above it is often the coldest one you have. Additions, sunrooms and porches that were closed in later often have a shallow space underneath with bare soil, open block walls and little or no insulation. Cold air moves through that space and pulls heat out of the subfloor from below.
Your feet notice it first. The room over the crawl space stays cold when the rest of the house is comfortable. Any water pipes running through the space sit in that same cold air during a hard freeze.
We start by looking into the space from the access hatch. We check what the ground is, whether the walls are block, poured concrete or wood framing, where the floor joists sit and what insulation is already in there. What we see decides the order of work on the quote.
Moisture first: the ground cover
A crawl space moisture barrier goes down before any insulation does. We lay heavy polyethylene sheet over the soil, lap each seam over the next and tape the laps. Then we run the sheet up the walls and fasten it there. That ground cover keeps vapour from the soil out of the air under your floor.
If there's standing water, or a wall that's wet to the touch, that gets dealt with before any insulation goes in. Insulation laid on a wet floor or against a wet wall just holds the water against the wood and the block. When the water is coming from grading, a downspout or a crack, we show you where, and that repair comes first.
On the day, you'll see rolls of sheet, tape, a utility knife and fasteners going in through the hatch. We string a work light inside so the crew can see the seams.
Insulating the walls or the floor above
You can insulate a crawl space in two places: on its walls, or in the floor framing above it. The right one depends on whether the space is going to be part of the warm side of the house or stay outside it.
Wall insulation makes sense when the crawl space has a sealed ground cover, holds plumbing or ductwork, and you want it kept close to house temperature. We fasten rigid foam board to the inside of the foundation walls or spray foam onto them. That puts the pipes and the subfloor inside the insulated area.
Floor insulation makes sense when the space stays open to outside air, or when the walls are too uneven or damp for foam to hold. We fit batts between the floor joists, snug against the underside of the subfloor, and hold them up with wire supports or netting so they can't sag. Pipes left below the batts are on the cold side, so they get their own wrap.
We go through both options with you on site. The quote says which one we recommend and why.
Rim joists in a crawl space
The rim joists are the boards sitting on top of the foundation wall that close off the ends of the floor joists. They leak a lot of air. The joint where wood meets masonry is rarely tight, and the board itself is thin, with the cold right on the other side.
We spray closed-cell spray foam into each joist bay at the rim, covering the sill plate, the rim board and the joint between them. One pass seals the gaps and insulates the wood at the same time. Batts stuffed into those bays leave air paths around their edges. Foam fills them.
Our spray foam crew handles rim joist work, either on its own or as part of a full crawl space job.
What crawl space encapsulation means
Crawl space encapsulation means sealing the crawl space off from the ground and the outdoors so it acts like part of the house. In practice that's four pieces of work: a sealed ground cover over the soil and up the walls, the gaps and openings in the walls closed, the rim joists sealed, and the walls insulated.
We tape the ground cover seams and fasten and seal the sheet along the walls. Vapour from the soil stays underneath it instead of getting into the air below your floor.
Once it's encapsulated, the space can stay vented or be closed off. Which way to go depends on the house, mostly how it's heated and where the moisture comes from. We talk that through with you on site rather than applying one rule to every house.
Old insulation in a crawl space
Old insulation comes out before new insulation goes in. Batts that have fallen off the joists or are lying wet on the ground get bagged in the space and carried out through the hatch, along with anything that has droppings or nesting in it.
If animals are living down there, a pest-control company deals with them first and we start once they're done. Then we take out the rodent-damaged material and clear loose debris off the soil before the ground cover goes down.
There's more detail on the tear-out on our insulation removal page. If we come across loose granular fill we can't identify, we stop and leave it alone. We'd ask you to have a qualified lab or abatement firm test it before any work goes ahead.
Getting into the space
Before we arrive, we need a clear path to the access hatch or crawl space door. Indoors, that means clearing the hallway and the floor around the hatch, and either unscrewing the hatch cover or telling us how it opens. Outdoors, the access door should be uncovered with nothing parked or piled in front of it. Anything stored in the crawl space needs to come out, or let us know ahead of time and we'll plan around it. Please keep pets in another room while bags, sheet and hoses are going in and out.
A crawl space quote should spell out each step so you can compare quotes line by line. Ours lists:
- Removal of any old insulation, and how it gets out of the house
- The ground cover: what material, how far up the walls it runs and how the seams are sealed
- The rim joists: spray foam, and which walls get it
- The walls or the floor above: which one we insulate, and with what
- Any repair that has to happen first, like standing water, listed separately from the insulation work
Booking a look at your crawl space
To have us look at the space, call (437) 563-1402 or visit our home page. We look first, walk you through the options, then give you a firm quote.
FAQ
Common questions about crawl space insulation
Crawl space encapsulation is worth it if the space is damp, has pipes or ductwork in it, or sits under a room that stays cold. Sealing the ground and walls keeps soil moisture out of the air under your floor and brings the space closer to house temperature. If the space is dry and you just want a warmer floor above, insulating between the joists may be the simpler job.
Insulate the walls if the crawl space has a sealed ground cover and holds plumbing or ducts. Insulate the floor above if the space stays open to outside air. With wall insulation the pipes end up on the warm side. With floor insulation they're left on the cold side and need their own wrap.
Yes. A crawl space with a bare soil floor needs a vapour barrier over the ground before any insulation goes in. The sheet stops moisture coming up from the soil into the space and into the wood above. We lap and tape the seams and run the sheet up the walls.
In a damp crawl space, fixing the water comes first, then the ground cover, then the insulation. Standing water or a wet wall has to be stopped at the source before anything goes over it. Once the space is dry, we lay the moisture barrier and insulate the walls or the floor above.
Get a quote
Book an insulation quote in Toronto
Call (437) 563-1402 or send the form. We'll come and look at the space, go over the options with you and give you a firm quote.