We are insulation contractors for Kingsview Village, about 5 km from us. The M9R postal area takes in Kingsview Village, St. Phillips, Martin Grove Gardens and Richview Gardens, and we take jobs in all four. Before we quote, we look at the attic, the walls and any space over a garage. Then we put the scope, the material and the bag count on a firm quote.

1950s and 1960s houses north of Dixon Road

Kingsview was the name given to the residential development north of Dixon Road in the 1950s. The name refers to the neighbourhood's position on high ground. The single family homes there were built in the 1950s and 1960s.

If one of those houses still has its original attic insulation, it usually needs two things: air sealing and a top-up. Attics of that age got far less insulation than goes in today, and the gaps around wires and pipes were left open.

We do the air sealing first. We go up through the hatch, pull the old insulation back from the top plates, and seal the holes around wiring, plumbing stacks and ceiling light boxes with foam and caulk. In winter, warm, damp air from the rooms below leaks up through those holes into the attic. Adding more insulation on top does not stop it.

Then comes the top-up. We fit baffles at the eaves to keep the soffit vents open, put tarps down from your door to the hatch, and run the hose up from the truck. Blown-in insulation goes on in an even layer over what is already there. We staple depth rulers across the attic floor so you can check the finished depth from the hatch yourself. Your quote names the material, the target depth and the bag count, and before we close up we weatherstrip the hatch cover and insulate it.

New houses on split lots

Many of the single family homes built in Kingsview Village in the 1950s and 1960s have been demolished. Some lots were subdivided to allow up to three homes on one parcel, and some smaller homes were replaced by much larger ones. So a newer house and an original one can sit side by side on the same street and need very different work.

A newer house may only need a check. If the attic depth is even from eave to eave, the baffles are in and the hatch is sealed, we tell you so and leave it alone.

Two places are worth a look on any house, old or new. A bedroom over a garage loses heat through its floor to the cold garage when that floor is short on insulation, and garage insulation in the garage ceiling fixes it from below. For an addition over a crawl space, we check the rim joist and the crawl space walls, since cold air gets to the floor above through both.

Work we quote in Richview and Martin Grove Gardens

Across Richview, Martin Grove Gardens and the rest of M9R, the list of jobs is the same as on the rest of this page: a blown-in top-up in the attic, batts or spray foam in a garage ceiling, spray foam on a rim joist, and tearing out old insulation before the new goes in.

If the insulation is part of a bigger renovation, tell us what else is changing. Each area gets its own line on the quote, so you can see what each part covers.

Neighbouring areas we cover: Westmount, Humberlea and Weston

We also work in Westmount, Humberlea and Weston, the areas closest to Kingsview Village. You can find every service we offer on our home page.

Local details for Kingsview Village

About Kingsview Village: Kingsview Village, ON on Wikipedia ยท Kingsview Village on Google Maps

FAQ

Insulation questions from Kingsview Village

Yes, if the attic still has its original insulation, it usually needs air sealing and a top-up. The houses built north of Dixon Road in the 1950s and 1960s got much less attic insulation than goes in now. We seal the top plates and the holes around wires and pipes first, then blow in new insulation to a depth you can read off the rulers.

A new house on a split lot may only need a check of the attic depth and the hatch seal. If both are fine, we tell you and do no work. A room over a garage or an addition over a crawl space still deserves a look, because those floors lose heat when they are short on insulation.

No, the City does not require a building permit to add or replace insulation in Kingsview Village. The work still has to meet the Zoning Bylaw. If the insulation is part of a bigger renovation, the rest of that job is a separate question.

Get a quote

Book an insulation visit in Kingsview Village

Call (437) 563-1402 or send the form. We'll come and look at the space, go over the options with you and give you a firm quote.

Call Text Quote