Garage insulation in Toronto mostly means two surfaces: the ceiling under a room above the garage and the wall the garage shares with the house. We insulate and seal those two, then hang and finish the drywall ourselves, so you are not waiting around for another trade to close things up. If you have a cold room over the garage, or cold air coming in from it, this page is for you, whether you live there or rent the place out.

The room over the garage

If a bedroom sits over your garage, the garage ceiling is that bedroom's floor. In winter the garage gets nearly as cold as outside, and the insulation between the joists is all that keeps the floor above warm. We do this work from below. We take down the ceiling drywall, fill the joist bays, seal the gaps to the house and then close it back up.

The gaps matter as much as the insulation does. Air moves easily where the joists run over the wall into the house, and anywhere a pipe, duct or wire goes through the ceiling. We seal those spots first. After that the bays get spray foam or batts, depending on how deep the joists are and how much is running through them.

On the day you will see tarps on the floor and over whatever is stored along the walls, a ladder or scaffold under the ceiling, and the old drywall bagged up to go out. Our quote puts the ceiling area, the insulation type, the air sealing and the new drywall on separate lines, so you can see what you are paying for in each part.

Walls shared with the house

We treat the wall between the garage and the house the same way as the ceiling: insulation in the stud bays and air sealing at every gap. Cold air and garage smells get in through the same openings, mostly the bottom plate along the floor, the electrical boxes and the space around pipes. We seal those with foam or caulking before any insulation goes in.

Watch the corner where the shared wall meets the garage ceiling. The top plate and the framing above it are easy to miss, and a gap there lets garage air into the wall and up into the floor of the room above. We open up enough drywall to get at it and seal it end to end.

If you can see light around the edges of the door from the garage into the house, air is getting through. New weatherstripping around the frame and a sweep along the bottom will close it up; that is a job for a carpenter or a door supplier, and we point it out on the quote.

Heated or unheated: what changes

If you heat your garage, the outside walls and the ceiling need insulation as well, because any surface that faces outdoors or an unheated attic loses heat. That adds the exterior walls to the job, along with the ceiling under the roof and a closer look at the garage door.

If you don't heat the garage, the surfaces that matter most are the ones next to where you live: the shared wall and the ceiling under any room above. Insulating the outside walls of an unheated garage takes a bit of the chill off the garage, but the rooms in the house barely notice. So for an unheated garage our quote starts with the shared surfaces and lists the outside walls separately, in case you want them too.

When nothing heated sits above and the garage has its own attic, the insulation goes on top of the ceiling drywall from the attic side. We work up there much the way we do for attic insulation in the main house. That means baffles at the eaves where they're needed and air sealing at the top plates, then insulation laid to depth and checked with a depth ruler.

Garage doors: kit or contractor?

For most garage doors, insulating it is a job you can do yourself. Hardware stores sell kits with foam or foil-faced panels cut to fit between the door's rails. They go in with clips or adhesive, and an afternoon is usually enough.

Most of the air actually gets in around the door. The rubber seal along the bottom and the weatherstripping on the sides and top wear out over time, and that is usually where the cold comes from. Replace worn strips before you put in a panel kit, or at the same time.

We stick to the walls and the ceiling, because that is where insulation and air sealing make a difference to the rooms you live in. If the door needs new panels, springs or tracks, call a garage door company for that part.

Spray foam or batts in a garage

Batts work well in open stud and joist bays that are clear and evenly spaced. They are fibreglass or mineral wool, cut to the width of the bay and pressed in by hand, and there is no curing time. When a wall or ceiling is fully opened up and nothing is crowding the bays, batts are the simpler option.

Spray foam is for the awkward spots. Think of tight joist bays full of pipes and ducts, the rim joist where the floor framing sits on the wall, and any gap where a batt would leave air moving around its edges. Foam seals the air as it goes in, so in those bays one product does both jobs.

Plenty of garages get both, with foam at the rim and around the edges and batts in the open bays. Our spray foam crew handles the foam. They are the same people who spray block walls and rim joists in houses across west Toronto. On the day the hose runs in from the rig, and anything that needs to stay clean gets covered in plastic sheeting.

Drywall after we insulate

Spray foam inside a building has to be covered with drywall for fire protection. So when we foam a garage ceiling or wall, we close it over instead of leaving the foam exposed.

We hang the drywall, tape and mud the joints, and sand it so it's ready for paint. You don't have to line up another trade to close the ceiling, and you get your garage back without bare foam or open bays. Walls and ceilings done with batts get the same drywall finish, and the drywall is its own line on the quote.

Permits for garage work

You don't need a City of Toronto building permit to add or replace insulation, though the Zoning Bylaw still applies. Insulating the ceiling and walls of a garage you already have counts as that kind of work.

You do need a building permit for an addition or a material alteration, like adding or taking out walls. Turning the garage into a bedroom or an office is a different project from insulating it, and you should talk to the city about it before anything starts. We insulate the garage as it is. The rest of what we do around the house is on our home page.

FAQ

Common questions about garage insulation

Yes, if there's a room above the garage. The garage ceiling is that room's floor, and it sits over a cold space. With nothing heated above, the ceiling matters less and the wall you share with the house should come first. If you heat the garage, the ceiling is worth doing regardless.

Insulate the garage door if you heat the garage. If you don't, the door does very little for the rooms you live in. Door kits are a do-it-yourself job, and new weatherstripping along the sides and bottom often helps more than the panels do. We work on the walls and ceiling, not the door.

No, you don't need a City of Toronto building permit to add or replace insulation in a garage, though the Zoning Bylaw still applies. You would need one if the job includes an addition or a material alteration, like adding or removing walls. Turning the garage into living space is a separate project, and you should talk to the city about it first.

Yes. We do it from below: we take down the garage ceiling drywall, fill the joist bays and seal the gaps to the house. Because we work from the garage side, nobody opens up the floor of the room above. Once the insulation is in, we hang and finish new drywall on the garage ceiling.

Get a quote

Book an insulation quote in Toronto

Call (437) 563-1402 or send the form. We'll come and look at the space, go over the options with you and give you a firm quote.

Call Text Quote